Skip to main content
(925) 999-4095 · 7AM – 7PM · 7 days · No overtime · CSLB #1136642
Bay Area HVAC Service

Danville · CSLB #1136642 · family-owned

Furnace Repair in Danville

Danville winters drop to the low 30s overnight, so when a furnace quits in January it gets noticed fast. We diagnose gas, electric, and heat pump systems and put the numbers on the estimate first.

Furnace Repair in Danville

Danville does not have a brutal winter, but 30-degree January overnight lows are enough that a dead furnace becomes urgent by morning. Most furnace calls here split along the same lines as the rest of our Danville work. Older Diablo Road and Danville Boulevard ranches from the 1960s through 80s tend to run original gas furnaces that are at or past 25 years, and at that age the failures are heat exchanger cracks, draft inducer wear, and gas valves that no longer seat. The Blackhawk and East Danville side runs newer multi-zone equipment where the problem is usually a control board or zone damper, not the burner.

On a gas furnace we start with the safety side. We test carbon monoxide, check the gas valve, and inspect the heat exchanger before we touch the repair conversation. On the older Diablo Road units a cracked heat exchanger is a real possibility, and if we find one we show it to you on camera and shut the system down. We do not quote a part you do not need.

Because Danville winters sit well inside heat pump range, a furnace that is 15-plus years old with a major failure is often the moment to run the heat pump conversion math instead of repairing. We check the panel capacity and the existing ductwork and lay out both numbers. Sometimes the repair is the right call for another season. We tell you which it is.


What we run into in Danville

Heat exchanger inspection on older Diablo Road furnaces. On 1960s through 80s ranches with original gas furnaces, a cracked heat exchanger is the failure we watch for. We scope it on camera, test CO, and if it is cracked we shut the system down and show you the documentation before we talk about anything else.

Hot surface ignitor and flame sensor service. The most common modern furnace no-heat call traces to a cracked hot surface ignitor or a flame sensor coated in carbon. The sensor often just needs cleaning. We carry both parts so a single visit usually solves it.

Control board and zone diagnostics in Blackhawk homes. Blackhawk and East Danville run multi-zone systems on Carrier and Lennox controls that drift over time. When one zone stops heating, the cause is frequently a board or a stuck damper rather than the furnace itself. We isolate it before quoting a furnace part.

Repair-versus-replace math on aging gas furnaces. A 15-plus-year furnace with a major component failure is usually the point to run the heat pump conversion numbers. Danville winters stay in heat pump range, so we check panel capacity and ductwork and put both paths on the estimate.


Furnace Repair in Danville: common questions

How fast can you get to Danville for a no-heat call?

We are based in San Ramon, the next town over, so Danville is one of our closest service areas. We aim for same-day on no-heat calls, best effort, not a guarantee. Call (925) 999-4095 and we will tell you honestly when we can be there.

My Danville furnace is from the 1980s and the heat exchanger may be cracked. Should I repair it?

A cracked heat exchanger is a safety issue and almost always means replacement, not repair. We confirm it on camera before quoting. Since Danville winters stay inside heat pump range, that is usually the moment to compare a new furnace against a heat pump conversion. We run both numbers at the estimate.

What does the $75 furnace diagnostic cover?

It covers a full system inspection: burners, heat exchanger, blower, controls, plus CO testing and gas valve diagnostics on gas units. The $75 is credited toward any repair over $200. Repairs carry a 1-year warranty; if the answer is replacement, a new install carries 10-year parts and 10-year labor.

Nearby and related

Furnace Repair near Danville: San Ramon · Alamo · Blackhawk · Walnut Creek · Pleasanton .

Other HVAC services in Danville: AC Repair · Ductless Mini-Split · Heat Pump Installation & Service · HVAC Installation · Maintenance Plans .

Common furnace repair problems in Danville: Furnace Blowing Cold Air · Furnace Not Heating .

See the full furnace repair overview or our Danville service area.

Furnace Repair in Danville

Free on-site assessment, written the same day.

Bay Area · 7am–7pm · 7 days · no overtime charges

(925) 999-4095 →

Call Now

Schedule a visit

Tell us what you need

  1. 1
  2. 2
  3. 3
  4. 4
What do you need?
Which brand?
What's wrong, or what do you need?
Where can we reach you?